SwiftMOD 2wd Raptor Diff Lock Module for Gen3 Raptors

Finally!! a way to lock your rear e-locker on Gen3 ('21+) Ford Raptors in 2wd!! This module is a "stand-alone" unit that you connect to your own switch (up-fitter switch or one from say a Switch-Pro output). Unfortunately there is no way to enable the factory push button on the 4wd knob, and the indicator on that won't come on. This module also has the "smarts" to turn off and use the factory diff lock controller if you activate it in 4wd. So in other words, they won't be competing, which would lead to bad things.

Installation on is pretty simple. NO CUTTING TO FACTORY WIRING HARNESS needed! YAY! This is because it includes a Y-harness. So you disconnect one 6-pin connector (above the rear axle) and plug this in between the 

two factory wire connector halves. Then run one wire to a ground, and one to an up-fitter output.

NOTE #1: It is highly recommended to turn off Advance-Trac when using this. We won't be held liable for any shinanigans that happen while using this module.

NOTE #2: The factory diff-lock push button will no longer work, nor will the diff lock come on automatically when you go into rock crawl mode. Not a big deal at all as you just flip your switch to turn on this module instead.

Wire colors on the "SWiftMOD" (the SwarfWorks Drift Mod):

Green = Up-fitter output or Switch-Pro output (up-fitter 5 or 6 work great as they are fused at 5A).
Black = Ground. There is a convenient ground location near where this module gets located.

What's included:

-Diff lock module (inside CNC billet aluminum case)
-Wire harness